1、保證正確的的操作順序：提升時，吊籠上升，安全裝置電磁鐵延時動作，使抱剎斜塊脫離立柱；下降時，先提升吊籠，當抱剎與立柱脫離后，上升停止，方可下降；停車時卷揚機制動受力，然后抱剎電磁鐵斷電，吊籠抱緊在立柱上；當發生斷繩時，吊籠上斷繩檢測開關動作，致使抱剎電磁鐵斷電，吊籠制停在立柱上，制止墜落事故的發生。
Ensure the correct order of operations in Ningbo rail lifting platform: the ascent, rising cage, safety devices, solenoid delay action, so hold off brake ramp block column; when dropped, first lifting hoists, when the brake and hold off the post rose stop before declining; winch brake force when parking, and then hold the brake solenoid power, to hold fast in the column cage; when breakage occurs when the rope, hanging off the rope on the cage motion detection switch, resulting in brake hold electromagnet power, cage system to stop in the column, stop falling accident occurred.

2、導軌式升降平臺保證剎車系統斜塊與立柱間隙為20mm，如在使用過程中發現間隙過小，即液壓升降平臺吊籠運行過程中出現卡阻，應及時調整其間隙。以既保證吊籠上下運行通暢、又有較好的抱剎效果為原則。
Ningbo lifting platform rail ramp guarantee brake system and the column gap is 20mm, as found in the course of the gap is too small, jammed hydraulic lifting platform hoists that occurred during the operation, should adjust the gap. In order both to ensure the smooth running up and down the cage, there are better hold brake effect principle.

3、導軌式升降平臺安全裝置中電磁鐵的牽引行程在15～20mm為宜，導軌式寧波升降平臺使用過程中如發現水平杠桿彎曲，可調整電磁鐵支架底座鋼板的位置，以不與水平杠桿相碰為宜，以保證抱剎效果。
Ningbo lifting platform rail safety device electromagnet traction stroke 15 ~ 20mm is appropriate, rail Ningbo lifting platform level course found bent lever, adjust the position of the base plate of the solenoid bracket, so as not to be consistent with the level of leverage touch is appropriate to ensure that the holding brake effect.