重慶升降機提升鏈起著至關重要的作用，所以保養好提升鏈條可以延長杭州貨梯的使用壽命，保證其使用安全性。下面有關技術人員就給大家詳細介紹一下提升鏈的維護方法。
  
1.鏈輪裝在軸上應沒有歪斜和擺動，不允許有摩擦鏈輪齒側面現象，如果兩輪編移過大容易產生脫鏈和加速磨損，在更換鏈輪時必須注意檢查和調整偏移量。起重鏈條的松緊度應適宜，太緊增加功率消耗，軸承易磨損；太松鏈條易跳動和脫鏈。
Hangzhou freight elevator sprockets on the shaft should not skewed and swing, does not allow the sprocket side friction phenomenon, if an offset is too large rounds off the chain and prone to accelerated wear, when replacing the

sprocket must be careful to check and adjust the bias shift. Tightness lifting chain should be appropriate, too tight increase in power consumption, bearing wear; the chain is too loose and easy to beat off the chain.

2、貨梯新的起重鏈條過長或經使用后伸長，難以調整，可看情況拆去鏈節，但必須為偶數。鏈輪磨損嚴重后，應同時更換新鏈輪和新鏈條，以保證良好的嚙合。
Hangzhou new freight elevator lifting chain or by the use of after a long stretch, it is difficult to adjust, you can remove the link to see the situation, but it must be even. Sprockets badly worn, it should also replace the new sprocket and new chain, to ensure good engagement.

3、貨梯舊的起重鏈條上不能與部分新鏈條混合使用，否則容易在傳動中產生沖擊，拉斷鏈條。
Hangzhou old freight elevator lifting the chain can not be mixed with some new chain, or prone to shocks in the drive, and pull off the chain.

4、貨梯起重鏈條在工作中要記得及時加注潤滑油。而潤滑油則必須進入滾子和內套的配合間隙，以便改善工作條件，以減少磨損。
Hangzhou freight elevator lifting chain at work in time to remember filling oil. The lubricant must enter the roller and the inner sleeve with the gap in order to improve working conditions in order to reduce wear.