1、使用升降貨梯必須配置經過專門培訓，考試合格，持證上崗的操作人員。 
Use cargo lifter must be configured through specialized training, examination, certificates of professional operators.
2、升降貨梯操作人員必須按照機械設備的保養規定，在執行各項檢查和保養后方可啟動升降平臺，工作前應檢查升降平臺車的工作范圍，清除妨礙升降平臺車回轉及行走的障礙物。支撐是升降貨梯操作的一項重要準備工作，應選擇平整的地面，如地基松軟或起伏不平，必須用枕木墊實后，才可進行工作。 
Cargo lift operators must follow the provisions of mechanical equipment maintenance, and after the implementation of the inspection and maintenance before they start lifting platform, lifting platform should check the working range of the car before work, remove prejudice lift platform trucks turning and walking obstructions. Support is an important cargo lifter operation preparatory work should choose flat ground, such as soft or rough ground, the pad must be real sleepers before work.
3、升降貨梯一般應先起下臂，再起中臂，最后起上臂。在升降平臺回轉操作過程中，必須在下臂起升一定高度后方可進行回轉，回轉應緩慢，同時注意剪臂及平臺對各設備的距離是否滿足安全需要。 在升降貨梯上工作的操作人員應佩帶安全帶，在帶電區域工作時，應將車體按規定進行接地，升降平臺登高作業應由工作負責人進行指揮。
Huoti general should be from the lower arm, renewed in the arm, and finally from the upper arm. In the process of turning operation of the lift platform must be carried out before starting the next swing arm up to a certain height, the rotation should be slow, taking care to cut the distance between the arm and the platform of the device meets the safety requirements. The operator on Huoti work should wear seat belts when working in the charged area, the body should be grounded in accordance with regulations, the lifting platform climbing operations carried out by the command of the responsible person.
4、升降貨梯作業前，工作負責人應向操作人員，進行技術和安全交待，內容應包括：工作內容及要求；安全注意事項及危險點；人員分工情況及責任范圍。工作負責人除要對車況 和操作人員進行檢查以外，還要負責查看地形環境、起降是否符合安全技術措施的要求或事先制定的工作方案，如有出入，則應制定出相應的措施后方能開始工作。 
Before lifting freight operations, responsible person should operators, technical and security account, which shall include: job content and requirements; safety precautions and dangerous point;personnel division of labor and responsibility. In addition to the work of the person in charge of the condition and operations personnel to inspect, but also for viewing terrain, landing compliance with safety requirements or technical measures to develop the program of work in advance, if different, should develop appropriate measures only after work.