升降平臺的潤滑工作是保養內容之一，其中減速機的潤滑比較重要，還有其它滾輪、中間軸及軸承；油缸銷軸及軸承；臂架鉸軸及軸承等潤滑保養工作。

1、潤滑油加注量以減速機體游標塞注滿向外溢出潤滑油為準，減速機采用N320蝸輪蝸桿潤滑油，當環境溫度低于零攝氏度時，應采用黏度較低的潤滑油。
Lubricant fill quantities in order to slow down the body to fill out the overflow plug cursor prevail lubricants, gear lubricants using N320 worm, when the ambient temperature is below zero degrees Celsius, the lower the viscosity of the lubricant should be used.
2、加入與原使用牌號相同的潤滑油，連續工作的減速機每6-8個月更換一次潤滑油。第一次使用時，運轉滿100小時時應更換新潤滑油。
Joined with the original use of the same oil grade, continuous work gear once every 6-8 months to replace oil. The first time, running over 100 hours should be replaced with new oil.
3、升降平臺減速機工作過程中，若發現潤滑油溫超過100攝氏度時或產生不正常的噪音等現象時，檢查原因，待排除故障后或更換潤滑油后方可繼續使用。
Ningbo lifting platform reducer work process, if found lubricant temperature over 100 degrees Celsius or produce abnormal noise and other phenomena, check the reason, be ruled out before continuing to use after failure or replacement of oil.
4、升降平臺減速機應在一年內認真檢查清洗一次，在各種零部件沒有明顯損壞的情況下，不要拆卸檢修及調整。
Ningbo lifting platform reducer should be carefully checked cleaned once in a year, in various parts of the case there is no obvious damage, do not remove the maintenance and adjustment.